|
Hampton Bay Motion Sensor Lights |
08/27/2004 08:03 AM |
rpena007 |
Bob,
Recently I installed 4 Hampton Bay Motion Sensor Lights in the exterior of my home. Two of them work like a charm. However, the other two just recently started malfunctioning. The switch inside the garage remains on of course supplying power two both lights. They have both operated properly for the past three months since installation. However, I have noticed for this past week that the lights are still on during the day with bright sun when I arrive home from work. I have made NO changes to the lights as they are exactly the same as when I installed them. I did try resetting them by turning the switch off for a couple of minutes then back on. The lights come back on as normal for about 20 seconds, blink three times to tell me they are functioning properly then turn off because they detect light. I checked them several times and they stay off until dusk. Again they do function properly when I reset them during the day as photocell keeps them off with sunlight. But once dusk they work fine but remain on at dawn and have to be reset now each afternoon. I could understand one sensor going bad but two? I would call hampton bay directly but cannot obtain their number. Any help you could provide would be much appreciated. |
Member Since
08/27/2004
Total Contributions
1 Posts
|
| Post Reply | Watch this Topic |
Hampton Bay |
04/01/2005 08:46 PM |
embdaw |
I have had this same problem. I installed 5 HB exterior lights and all 5 no longer turn off during the day. They are just under 6 months old, and the first began malfunctioning after only 2 months...any suggestions!!!
~*~Erin~*~ |
Member Since
04/01/2005
Total Contributions
2 Posts
|
| Post Reply | Watch this Topic |
THESE LIGHTS MAY CATCH ON FIRE. |
01/22/2006 04:43 PM |
MaxH42 |
I just had a Hampton Bay photovoltaic cell MELT on me. The dawn-to-dusk ones, without the motion sensors, we have two by our garage, and one was staying on all the time. I replaced the bulb and shone a flashlight at the cell (underneath the fixture), and I saw it was glowing like a lit cigarette. The plastic started to melt, and I watched in disbelief a few more seconds and ran for the switch.
If anyone finds the number for the mfr, please post it here.
-Max |
Member Since
01/22/2006
Total Contributions
4 Posts
|
| Post Reply | Watch this Topic |
Hampton Bay Helpline #'s |
01/22/2006 06:15 PM |
doug seibert  |
1-877-527-0313
1-800-841-1350
and another 1-800-749-3267 |
Member Since
08/11/2002
Total Contributions
2102 Posts
|
| Post Reply | Watch this Topic |
Thanks! |
01/22/2006 06:24 PM |
MaxH42 |
Wow, thanks! This is a Hampton Bay "UPC# 25916814205", "SKU# 240-336", and "Vendor: 11370". I found a discussion of them here: http://www.bobvila.com/BBS/Lighting/160/160/flat-page1.html |
Member Since
01/22/2006
Total Contributions
4 Posts
|
| Post Reply | Watch this Topic |
Hampton Bay's Exterior Lighting |
01/22/2006 09:34 PM |
fourchalk  |
After reading all the negative comments about Hampton Bay's exterior lighting, I would hope that all defective products are being packed up for return to Home Depot.
I couldn't think of a quicker remedy than to have Home Depot return car loads of defective products to the manufacturer.
Frank Fourchalk
Security Consultant/Columnist
http://www.yourhomesecurity.ca |
Member Since
01/19/2006
Total Contributions
21 Posts
|
| Post Reply | Watch this Topic |
Report it. |
01/22/2006 09:45 PM |
MaxH42 |
Actually, I already filled out a report on http://www.cpsc.gov/ . |
Member Since
01/22/2006
Total Contributions
4 Posts
|
| Post Reply | Watch this Topic |
scary |
04/30/2007 12:24 AM |
HammerTime01 |
that's a freaky situation |
Member Since
04/19/2007
Total Contributions
27 Posts
|
| Post Reply | Watch this Topic |
 |
 |  |  |